Walltalkers colonial trim & tray Manuale Utente Scaricare il pdf

colonial wood trim & tray installation instructions

www.walltalkers.com

1. Examine goods to assure quantity and quality are as ordered.

Lay out all the work to be completed along the base of the wall.

The parts will include those supplied by walltalkers and those the

installer must supply. Walltalkers supplies the wood trim (with

wood insert) and tray in the quantities ordered. The installer must

supply the mounting hardware, wood filler, and touch-up finish.

All trim should be installed with condition appropriate hardware

16" on center, slightly offset from the trim hardware locations, as

show below on the right.

2.Install the walltalkers or tac•wall material prior to the trim

and/or tray. Overlap the edges of the dry erase or tackable

material with the trim. Overlapping will ensure a good

appearance for the finished product.

. Measure, mark, and cut the wood trim pieces to size. The interior

dimension of the finished trim pieces should be 1" to 1-1/2" shorter

than the perimeter measurement of the dry erase or tackable

surface. See the reverse side of this page for an illustration. Use a

miter saw to cut the corners at 45° angles, similar to a picture frame.

For best results, cut the wood trim and wood insert simultaneously

(

double-sided tape may be used to securely hold the insert in place).

low profile hook and loop fastening system may be used to hold

the insert in place for this operation, and to secure the insert in place

on the wall to finish the trim system. Assure the finished trim pieces

are square prior to gluing and mechanically fastening to the wall.

Remove the wood insert to install the trim.

4.For walls with wood backing or studs, begin installing the trim pieces

with #10 X 2" flat head wood or sheet metal screws, 2-1/2" for

tac•wall version. Mark holes at each stud or 16" on center with

solid wood backing, centered in the channel as shown above. The

vertical wood pieces of trim may require the use of drywall anchors

to securely fasten the wood to the wall. Predrill, using a 1/8" bit,

through the trim at every mark. Use a countersink bit to make a

slight indentation at each screw hole. Begin installing the trim with

the recommended screws. For the bottom trim piece, screws must

make a solid contact with the wall studding or wood backing to

properly support the marker tray. For installations on cement,

block, or other substrate, use condition appropriate hardware

(i.e. masonry anchors, self-tapping screws, etc.).

a division of Koroseal Interior Products, LLC

Colonial

tac•wall

Trim

Colonial

walltalkers

Trim

5/16"

/16"

2-3/4"

-1/8"

2-1/2"

13/16"

2-3/4"

3/16

Colonial Tray

Note: Follow the same instructions for walltalkers

ac•wall

tac•wall

Stud

Drywall

Stud

Drywall

1 2

Sommario

Pagina 1

colonial wood trim & tray installation instructionswwww.walltalkers.com1. Examine goods to assure quantity and quality are as ordered.Lay out all

Pagina 2 - 1/2" to 3/4"

colonial wood trim & tray installation instructionswwww.walltalkers.com5. Adhere the wood insert into place. If a low profile hook and loopfasteni

Più documenti per Per casa Walltalkers colonial trim & tray

Per vedere il documento Walltalkers colonial trim & tray Manuale Utente

Walltalkers colonial trim & tray Manuale Utente (2 pagine)

Commenti su questo manuale

Nessun commento

Walltalkers colonial trim & tray Manuale Utente

Navigare online o scaricare Manuale Utente per Per casa Walltalkers colonial trim & tray. Walltalkers colonial trim & tray User Manual Manuale Utente

Sommario

Più documenti per Per casa Walltalkers colonial trim & tray

Commenti su questo manuale

Prodotti e manuali riguardandi Per casa Walltalkers colonial trim & tray